EhS 45° "Solo Anchor" System

EhS 45° "Solo Anchor" System
DW15 / DW20

The quick reanchoring system to support frames for single-sided formwork!

Please request installation instructions!

This one-pieced anchor will be supplied pre-assembled, ready for installation. It consists of 2 Steel Sleeves with DW15 or DW20 thread,
connected by a welded assembly bow in 45° angularity. A PE-45° Recess is included.
The anchor point can be easily treated by a screed board and a finishing trowel and recognized again.
The PE-45° Recess leaves a suitable large space for filling compound.
The Recess can also be used for screed floors.
For anchoring out of walls:
The anchor will be used with our PE-45° Recess too. When closing the formwork the Recess will be tightened to the panel. After stripping formwork remove Recess with a plier and sleeve is ready for screwing in the thread rod.

B e n f i t s :

Quick and simple installation:
only 1 person needed
- tie to upper reinforcement
b e f o r e concrete casting !
Additional reinforcement not required
the threaded rods are reusable
no grinding off und or corrosion protection necessary
minimal finishing required
no more expensive conncting cones

EhS 45° "Solo Anchor" System DW15/G
The anchor is provided with PE-45° Recess
for assembly in concrete plates thickness greater than 25 cm

permiss. load P 45°:
DW15: 85 kN / 17 N/mm² – DW20: 140 kN / 30 N/mm²

These values were confirmed by tension tests with 45°-angularity at
MPA NRW, Germany. Test certificate upon request.

EhS 45° "Solo Anchor" DW15/G
Length without Recess: about 29 cm
with assembly bow for 45°-angularity
for assembly in concrete plates thickness greater than 25 cm
(from 18 cm thickness upwards upon request)

Verankerung EhS 45° "Solo" DW20/G
Length without Recess: about 33 cm
with assembly bow for 45°-angularity
for assembly in concrete plates thickness greater than 30 cm
(from 25 cm thickness upwards upon request)

for reanchoring out of walls:

By using the PE-45° Recess a perforation of formwork is no longer required.